This is known as “the certification label number”. This identifying number is different for every manufactured home in the country. There will be 3 letters, then a dash, followed by 6 numbers. You will find within the first sentence of the aluminum HUD Tag a number that is etched in. The labels shall be stamped with numbers sequentially.” What Is The Label Number That On The HUD Tag? Each label shall be marked with a 6 digit number which the label supplier shall furnish. The label number shall be etched or stamped with a 3 letter designation which identifies the production inspection primary inspection agency and which the Secretary shall assign. in size and shall be permanently attached to the manufactured home by means of 4 blind rivets, drive screws, or other means that render it difficult to remove without defacing it. Section 328.11(b) states, “The label shall be approximately 2 in. The certification label (also known as a HUD tag) is a metal plate that is affixed to the outside of the manufactured home. See data plate.” What Is The HUD Requirement For The Tag? “The manufacturer certifies to the best of the manufacturer’s knowledge and belief that this manufactured home has been inspected in accordance with the requirements of Department of Housing and Urban Development and is constructed in conformance with the federal manufactured home construction and safety standards in effect on the date of manufacture. HUD TagĮvery manufactured home “red tag” that is manufactured in the U.S. But, everything is required to be etched into the metal tag, so you should be able to read the label. You might find a pink tag, or one that just looks silver, depending on how old the home and tag is. The tags start out as red, but like a red car, they tend to fade badly over time. The official name given by HUD is the “Certification Label”. It is sometimes referred to as the “red tag”. Since the tag is silver writing over a red background with silver writing. This has been required by HUD on every manufactured home built since June of 1976. This metal tag generally should be attached to the rear of the home, usually about a foot from the side and a foot up from the bottom. In general, people will refer to this as the HUD label. A single wide has one tag, and a double wide will have two tags. The tag, issued by HUD (Department of Housing and Urban Development) is a 2” by 4” plate made of metal that is attached to an exterior wall of each section of a mobile home.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |